Air Boosters

Product Detail

Shenzhen IVS Flow Control Co.,Ltd is one of the leading air boosters manufacturers and suppliers in China, welcome to wholesale customized air boosters from our factory.

AB & ABD Series Air Booster
IVS offers a complete selection of air boosters for almost any application. From economical compact single-acting two and four-to-one models to double-acting two and five-to-one models we can size a unit or system to fit your exact requirement.
The principle of the air booster works much the same as our liquid pumps in which a larger air drive piston is directly connected to a smaller pumping piston. The incoming air from the compressor drives the booster and also feeds the supply to the unit. Pressures can be boosted up to 680 psi on the single-acting AB-7 and as much as 850 psi on our double-acting ABD-5.
All IVS air boosters are pre-lubricated at the factory and should not be used with inline air lubricators. Clean, dry air is very important as any grit, moisture, or foreign matter in the air supply can damage the high pressure components. A coalescing filter is recommended before the air supply and air drive inlet, which can be the same.
Typically, air boosters are used to build up pressures for static holding applications. Under normal, intermittent duty, the air cycling valve should be inspected and re-lubricated after 500,000 cycles. For continuous operation the booster should not be operated at more than 40 cycles per minute and should be inspected and re-lubricated every 150,000 cycles or 60 operating hours.
Typical Application
Engine air starter systems
Top off high pressure tires
Release spring actuated brakes
Increase maximum torque on small air tools
Top off and maintain pressure in die cushions
Increase marginal air pressure to valve actuators
Extra force for small air clamps, roll tensioners, assembly machines and air presses

ORDERING HIGH PRESSURE GAS BOOSTER

MODEL SELECTION CHART
Model No.	Maximum Rated Air Supply (Ps)	Maximum Rated Air Outlet (Po)	Connection Ports			Static Outlet      Stall Pressure	Actual Area Ratio	Displacement Per Stroke      (in3 per cycle)
			Air Drive	Air Inlet	Air Outlet
AB-2	150 psig	300 psig	1/4" NPT		1/4" NPT	2 Pa	2:1	`2.9
	10.3 bar	21 bar
AB-4	150 psig	600 psig	1/4" NPT		1/4" NPT	4 Pa	4:1	1.4
	10.3 bar	41 bar
AB-7	150 psig	700 psig	1/4" NPT		1/4" NPT	7 Pa	7:1	.7
	10.3 bar	48 bar
ABD-2 & ABD-2S	150 psig	300 psig	3/4" NPT	1/2" NPT	1/2" NPT	Pa + Ps	2:01	223
	10.3 bar	21 bar
ABD-5	150 psig	855 psig	3/4" NPT	1/2" NPT	1/2" NPT	4.7 Pa + Ps	4.7:1	28.2
	10.3 bar	59 bar

Note:Limited modelslisted. Please consult our Sales Representative for High Pressure Components if you don't see models that meet your requirement.